4P90HU Craftsman T 1000 T1000 247.203701 247203701

    GENERAL DISCLAIMER - PLEASE READ! The following engines on this page have some similar specifications as your CRAFTSMAN T 1000's engine.

Although any of these engines may not be exactly (100%) the same as for your CRAFTSMAN T 1000's engine , we feel very confident and are doing our best from our many years of experience to show you the closest engines we have in stock that have some similar specifications as your original engine, such as crankshaft diameter and length and mounting bolt pattern that may work for your equipment. Your exact original engine may not be available because it may: be too old to be in production or discontinued due to some EPA regulations.

Our customers may had bought any of these engines from us and may had done some modifications to adapt to work with their equipment including, but not limited to: transferring the wire harnesses from their old engines to the new engines, tappering the mounting holes, drilling new mounting holes on mower's decks, cutting and welding mufflers, ...etc.

Although we spent a lot of time to prepare, review and compose this page, the information here may not be 100% accurate as we collected them from our experience and from our customers on the daily basis. You should replace your old engine with the same brand, type, and series, specifications to avoid major modifications. Please contact us first if you have any questions or want to confirm before purchasing. We are here to help!
OUR POSSIBLE REPLACEMENT ENGINES FOR

CRAFTSMAN T1000 with: Model# 247.203701 and MTD
4P90HU


Our engines on this page have the following similarities. Choose the engine HP and the displacement (cc) accordingly to fit your needs:
    1. Bolt pattern - The mounting hole pattern are the same.
    2. The dimmension.
    3. Muffler configuration is the same (you can reuse your old muffler)
    4. Although spent a lot of time to carefully study about your engine, prepare, review, and compose this page to believe that your engine crankshaft size is 1" diameter x 3 5/32" length, it is still your responsibility to measure your engine crankshaft to double check if it is the same.

Other minor things that you may have to do when you buy the long block to replace your engine including but not limited to: transfer your wire harness from your old engine to the new one if it is not the same (most of these have similar wire harness though), tap/thread the mounting holes (as most of brand new engines did not have the mounting holes threaded/tapped by the manufacturer) etc..

YOUR EQUIPMENT
BRAND & SERIES
YOUR ENGINE BRAND, MODEL, SPEC/TYPE #
Sears Craftsman decimal point Model #
OUR POSSIBLE REPLACEMENT ENGINES
(If you matched your equipment's information on the left, buy one of the following engines )
CRAFTSMAN
T 1000

Make sure you find one of these following model numbers on a sticker (most of the time under the seat):
247.203701



This equipment series ( T 1000 ) used to guide you here. Don't use only this to get your engine.

Use the full engine MODEL and TYPE/SPEC number or the decimal point Sears Craftsman Model # (e.g., 917.123456 usually found under the seat) on the right of this column to look for your replacement engine accordingly.
Make sure your mower has ALL of the following information or CALL us!
MTD  ENGINE

4P90HU

and this Model Number may be found under the mower's seat:

247.203701 or 247203701


Your engine choke may be (double check): CHOKE/THROTTLE COMBINED (Mower needs just 1 control cable to do both choke & throttle)



 You may have to reuse your old engine muffler.

CLICK HERE TO ORDER THE REPLACEMENT ENGINE